Support Line

Create Support Line

Command	SOF_SE_TENDONSUPPORT
Tooltip	Creates support lines for the positions of spans along the tendons.

Modify Support Line

Command	SOF_SE_TENDONSUPPORT_M
Tooltip	Modifies support lines for the positions of spans along the tendons.

Creates support lines for the positions of spans along the tendons.

Support lines are created on the layer X___TEND_ASDWG. These elements define the geometry of tendons in elevation.

Support lines can be modified using the AutoCAD commands ‘Copy’, ‘Mirror’ and ‘Move’. Additionally, support lines can be modified using the AutoCAD grips in the drawing.

Support lines can be added later, deleted or moved. The position of the ‘Top Position’ of the affected tendons are adapted accordingly.

Available options:

For creation of support lines, the following options are available for use:

Draw Support Line

Creates a support line with the selection of a start and end point.

Create Support Line from Curve

Converts lines and Splines into support lines. The original line remains unchanged.

End

Ends the command.