Service-Pack 2025-10#

SOFiSTiK Structural Desktop#

Cross Sections and Materials#

Bugfix

  • Prestressing steel “SNIB 500” corrected to reinforcing steel “SNIA 500B” according to SP 52-101-2003. (246454)

  • In the case of wide webs of box girders with a continuous shear cut the resistance 1/WTm was corrected. (246999)

Interactive Pre- and Postprocessors#

Viewer#

Interactive System Visualization Tool

Bugfix

  • Fixed a crash occurring when closing the standalone Viewer, present since March (caused by an incorrect COM uninitialization order).

Result Viewer#

Graphical and Tabular Post-Processing

Bugfix

  • Sometimes, after an interactive selection of the beam section, an incorrect cross-section number was used for the cross-section stresses of beams (or structural elements or external beam sections). (246436)

FEA Modules for Batch Processing#

TENDON#

Geometry and Forces of Tendons

Bugfix

  • Fixed incorrect “is inside box-girder” check. Falsely detected distant cross-sections as box-girder. (246095)

ELLA#

Extended Live Load Analysis

Bugfix

  • Correction to the handling of transversal springs defined by two separate nodes.

BEMESS#

Design of Plates and Shells

Bugfix

  • Punching longitudinal reinforcement for WINGRAF had been faded out too much near punching nodes at wall ends, corrected. (246303)

  • Storage of nodal reinforcement in case some groups are switched off : corrected. (246408)